Satellite Industries, Inc.

Protecting homes and businesses for more than 30 years

FBI XL-2 Users

Scroll to the bottom for Users Manuals

Problems Arming

If your system will not arm, check to ensure that all protected areas are secure (closed). Your AC/LOW BATTERY light will indicate (ON) when your system is running on power or (OFF) when it is running on your back-up battery. The back-up battery will not sustain your system for more than 48 hours, please contact us if power has resumed and if after 48 hours your low battery light is still lit. It may need to be replaced, the average life span of a panel battery is 4-5 years.

System Not Ready

If the system is not ready to be armed the READY indicator will be OFF. On LED keypads the zone indicator lights will display the zones which are currently not ready. The condition of each zone indicator reflects what the status of each zone is as follows:

ALARM: Fast Blinking

BYPASS:Slow blinking low intensity

TROUBLE:Slow pulse

NOT READY: Solid ON

The LCD keypad will display the zone not ready

Check the zone(s) indicated on your keypad to make certain that your window(s), doors, etc. are closed.

Changing/Adding/Deleting User Codes

Adding/Changing User Codes:

Users can be entered or modified directly through the keypad. You may have up to six different users. User #1 is known as the master user and is the only user allowed to modify other users.

To add or change a user press CODE on the keypad, enter your master code, press the number (1-6) to add or change user # 1,2, 3, 4, 5 or 6, then press * and enter in the 4 digit user code. If you are changing the master code you will be pressing 1, if changing or adding user #5 and our technicians have programmed this as a "maid code", then user 5 will only be able to arm the system. If changing or adding user #6 and our technicians have programmed this as an ambush or duress code, please only use this code in ambush or duress situations NOT as a code to arm and disarm the system under normal conditions. Any error detected during this process will cause the keypad to beep rapidly four times. If an error is detected retry the entire command procedures.

Deleting User Codes:

Press CODE on the keypad, enter your 4 digit master code, press the user # (2-6) and then press *. (User number 1, the master code cannot be deleted, it can be changed, however.

ALWAYS CHECK YOUR CODES TO ENSURE THE SYSTEM HAS ACCEPTED YOUR CHANGES BY ARMING AND DISARMING YOUR SYSTEM!

Users manuals:

Call us if you need to set up a service appointment at:

(301) 840-5420